4.08.2018

The Stories We Make Up.

So thankful for the wonderful and smart readers of this blog who ask more questions. It holds me accountable. It challenges my thinking and removes the stories we make up in our heads. 

If I write something that makes you wonder, ask me about it.

I'm not expecting perfection in my personal growth journey. I will screw this up over and over and over again. But I'm perfectly in progress and learning every step of the way. 




1 comment:

  1. Injection molding components are finished with little postmolding operations in very fast cycle occasions. When filling a new new} or unfamiliar mould for the primary time, where shot measurement for that mould is unknown, a technician/tool setter could carry out a trial run earlier than a full production run. They start with a small shot weight and fills progressively till the mould is 95 to 99% full. Once they achieve this, they apply a small quantity of holding pressure and increase holding time till gate freeze off has occurred. Gate freeze off time can be decided by increasing the maintain time, after which weighing the half. When Bicycle Lock the burden of the half does not change, the gate has frozen and no more material is injected into the half.

    ReplyDelete